Processors By xcluma

• Module usb to ttl serial uart stc download cable
• Upgrade for arduino
• Durable and long-lasting

• Brand new and professional high quality delay switch module With power indicator LED and trigger indication LED
• Output is voltage free & can be connected up to 10A load of any voltage rating Chrono-potentiometer regulation time delay, adjustable from 0 to 10 seconds by default Useful for applications in equipment-delay to prevent sudden high current which can burn components and devices
• Module based on: NE555 chip Delay module: delay connect module Input voltage: DC12V Control voltage: AC 0~250V / max. 10A, DC 0~30V / max. 10A, the operating voltage: 12 volts DC Max load: 2200W

• Communication Chip:Max3232 Chip Operating Voltage: 3.3v~5v
• Four Interface:Vcc,Gnd,Rxd,Txd Dimensions: 33mm*32mm*16mm
• It Is Widely Used In Radio Modification, Phone Flash, Xbox360 Flash, Gps,Vehicle Detection, Dvd Flash, Hard Disk Repair Etc.
• It Can Be Used To Program Stc Mcu,Nxp Mcu,Renesas Mcu,Stm32 Mcu,N+-2ec Mcu

• Mfrc522 Is Applied To 13.56mhz Contact-Less Communication Highly Integrated Chip Card Reader,Is Nxp For The \"Three Tables\" Application Launch Of A Low-Voltage, Low-Cost, Small Size And Non-Contact Card Reader Chip
• Smart Instrumentation And Portable Hand-Held Devices Developed Better Choice. Mf Rc522 Using Advanced Modulation And Demodulation Concept Completely Integrated In All Types Of 13.56mhz Passive Contact-Less Communication Methods And Protocols. Support 14443a Compatible Transponder Signals.
• The Digital Part Handles Iso14443a Framing And Error Detection. In Addition, Support Fast Crypto1 Encryption Algorithms, Terminology Validation Mifare Products. Current :13-26ma / Dc 3.3v Idle Current :10-13ma / Dc 3.3v Sleep Current<80ua Peak Current<30ma Operating Frequency: 13.56mhz<30ma

• Chip: KA2284 Supply voltage: 3.5V-12V The magnitude of the level can be adjusted AC and DC signals can be controlled by jumper
• PCB board size: 29 (mm) x21 (mm) Adjustable span of power level AC and DC signals can be controlled by jumper Perfect for Arduino DIY project

• Intelligent reverse polarity protection, power supply reverse polarity will not damage the IC. IC control circuit and a power LED spot light utility.
• Control circuit chip with RGB components in a package in 5050, to form a complete external control pixels. built-in signal shaping circuit, any one pixel after receiving the signal through the waveform shaping and then output to ensure line waveform distortion will not accumulate.
• Built-in power-on reset and brown-out reset circuit. trichromatic color of each pixel can realize 256 highlighted, complete 16777216 colors of all true color display, the scanning frequency is not less than 400Hz / s.

• The 127 couples, 40mm x 40mm size module is a single stage module which is designed for cooling and heating up to 90

• Microcontroller ATmega328P; 100% compatible with Arduino
• Must Have for Arduino Projects
• Operating Voltage : 5V; Input Voltage (recommended): 7-12V
• Digital I/O Pins : 14 (of which 6 provide PWM output) Analog Input Pins: 6
• Flash Memory: 32 KB (ATmega328) of which 0.5 KB used by bootloader SRAM : 2 KB (ATmega328) EEPROM: 1 KB (ATmega328) Clock Speed: 16 MHz

Popular Categories on BuyBestBrands.in