Robotics By Generic

• Supply Voltage : 5V
• Operating Frequency : 125KHz
• Read Distance : 10cm
• Current Rating : < 50mA

• Support control of 10A 30V DC and 10A 250V AC signals
• 5V 8-Channel Relay interface board; LOW level trigger, equipped with indicator easy to recognize the working status
• Each relay has NO and NC ports, easier to connect and control the connected devices
• Selection of plastic material for high temperature and better chemical solution performance
• PCB size: 5.7 x 13.8 cm

• Connector Type: DC 5.5/2.1mm
• Connector type DC mains
• Electrical mounting screw terminal
• Length of metal part 12mm
• Spatial orientation straight

• It has special areas for small screws, IC Chip and other small parts.
• This Silicone work Station mat is Insulation, Retardant, Anti-skid, Anti-static, Anti-corrosion, Magnetic Storage, Odorless, and is Foldable.
• Also, Suitable for working with hot air gun and for Heat Gun BGA Soldering stations.
• The mat has specific space for small screws, IC chips and other repairing tools. The large size makes it spacious enough for comfortable for Repairing.

• Chip: LM393 (stable operation)
• Operating voltage: 3.3V-5V
• Power Indicator (RED)
• DO LED(GREEN)
• Mode: Dual output mode (accurate output)

• Size: 150x150x150 mm .
• Material : Cast Iron
• Color : Any which available in stock
• Can be used In laboratory work
• To check strength of concrete
• Heavy quality and well packed

• High performance- ratio,small vol, easily embeded to other products,strong function with support lwip protocol, freertos,supporting three modes: ap, sta, and ap+sta,supporting lua program, easily to develop
• Development board
• Package content: 1 squadpixel esp-32 wifi , bluetooth, dual core chip development board

• Resistor Value: 250 ohm
• Wattage: 1/4W
• Tolerance: 1%
• Type: Carbon Film Leaded

• Very High Input Impedance (ZIN) -1.5Tohm (Typ); Output Swing Complements Input Common Mode Range
• Very Low Input Current (Il) -10pA (Typ) at +15V; Directly Replaces Industry Type 741 in Most Applications
• Wide Common Mode Input Voltage Range (VlCR) Can be Swung 0.5V Below Negative Supply Voltage Rail
• Applications:- Ground-Referenced Single Supply Amplifiers in Automobile and Portable Instrumentation; Sample and Hold Amplifiers; Long Duration Timers/Multivibrators (us-Minutes-Hours); Photocurrent Instrumentation; Peak Detectors; Active Filters; Comparators; Interface in 5V TTL Systems and Other Low; Supply Voltage Systems; All Standard Operational Amplifier Applications; Function Generators; Tone Controls; Power Supplies; Portable Instruments; Intrusion Alarm Systems
• Packaged by:- Sharvi Technologies (OPC) Pvt. Ltd.; Address:- #09, CK Nagar, AECS layout, Hosa Road, Bangalore-560100

• Model number is 41F, TO-92S, 0H41, SH41, SS41F, S41.
• 4.5 V to 24V operating voltage, used for electric vehicle or industrial motor.
• 25 mA output current works with most of open-collector.
• Operating temperature is -40 degreeC to +150 degreeC, 3 pins terminals length about 15mm/0.59inch.
• And also the ideal parts for electric bike or scooter brushless motor repair parts.

• Plug-n-play, Easy to use
• Use: experimental, testing, robot, Phosphor bronze nickel plated spring clips
• Matching jumper, diameter 0.8mm
• Components are easily interconnected using 20-28 AWG wire
• Adhesive-backed for permanent mounting.

• For fast iot prototyping
• It is flashed with the nodemcu firmware and can be set up and programmed right away with the on-board microusb connection
• The d1 mini is a mini wifi board based on esp-8266ex

• Value: 180 ohm
• Wattage: 0.25W

Popular Categories on BuyBestBrands.in