Motherboard By sunrobotics

• Module 5V DC power supply, SPI interface protocol control
• 8MHZ crystal oscillator
• 0 to 8 bytes long data field.
• The working current: typical 5mA, standby current 1 microamp. Except for the power indicator.
• Use High-speed CAN transceiver TJA1050

• Operating Voltage: 5V
• Fixing screws with 64 holes with a diameter 3mm.
• The input port is in the left side of module, and the onput port is in the right left of that.
• Module with input and output interfaces, support for cascading multiple modules.
• Size: Approx. 12.8×3.2×1.3 cm/ 5.04×1.26×0.51 inch

• Science & Discovery
• Plastic Material
• No batteries Battery
• Non Rechargeable
• Width x Height: 20 mm x 73 mm

• Digital light intensity detection
• Data range 0-65535
• Sensor built 16bitAD converter
• Direct digital output, omitting complex calculations, calibration is omitted
• Does not distinguish between ambient light

• Low power consumption
• Power supply for 2 ~ 5.5V DC
• Can replace the traditional touch of a button
• Four M2 screws positioning holes for easy installation

• Resolution 320 x 240, RGB565 format
• SPI LCD data bus
• LCD controller ILI9341
• Touch panel controller STMPE6
• Expanded available I/O pins

• Working voltage: 2 V to 5.5 V DC
• key output mode
• longest time and fast/low power output
• PCB board size: 35(mm) x29 (mm)

Popular Categories on BuyBestBrands.in